To Configure Rev X-Tend

Some models of Power Commander V allow you to increase the maximum RPM above what the stock electronics allow.

If you have more than one module, you must sync the modules. For more information, refer To Configure the Sync Devices Utility.

1	Select Power Commander Tools >Configure >Feature Enables and Selection Inputs.

2	Select the On/Off box to enable or disable Rev X-tend.

3	Click Configure to open the Rev X-tend Configuration window.

4	Enter the Key in the Load Key text box.

Before entering the key, all devices must be powered up either with a USB cable to each module or with the vehicle running.

You will need a key to activate the Rev X-Tend feature. The key is available from your Dynojet salesman.

5	Click Load Key.

6	Click OK to accept the changes.

Or

Click Cancel to close the window without changes.